Cisco Headend System Release 2.5 Guia Da Instalação
I-4
SR 2.5/3.5 Direct ASI Installation and Configuration Procedures
78-738190-01 Rev B
Install the ASI Package
Installing the ASI Package
After installing the ASI card into the DNCS, follow these instructions to install the
ASI package.
Note: If you have properly followed the instructions in the previous procedure, you
Note: If you have properly followed the instructions in the previous procedure, you
should be logged on as root user to the DNCS.
1. Type . /dvs/dncs/bin/dncsSetup and then press Enter.
Important: Be sure to type the dot followed by a space prior to typing
/dvs.
Result: The system establishes the root user environment.
Result: The system establishes the root user environment.
2. Insert the CD labeled similarly to SAIasi into the cdrom drive of the DNCS.
3. Type df -n and then press Enter.
Result: A list of the mounted filesystems appears.
Note: The presence of /cdrom in the output confirms that the system
Note: The presence of /cdrom in the output confirms that the system
correctly mounted the CD.
4. Type cd /cdrom/cdrom0 and then press Enter.
5.
Type ./install_pkg and then press Enter.
Result: Software installs which prepares the DNCS for Direct ASI support.
Result: Software installs which prepares the DNCS for Direct ASI support.
6. Type eject cd and then press Enter.
Result: The CD ejects from the DNCS.
7. Go to Check the Status of the ASI Card, next in this appendix.