Cisco Headend System Release 2.5 Guia Da Instalação
I-22
SR 2.5/3.5 Direct ASI Installation and Configuration Procedures
78-738190-01 Rev B
Set Up the BFS Host,
Continued
4. Follow these directions to configure the Set Up BFS Host window.
a) In the BFS In-Band Mode field, select ASI.
b) In the Inband Device Name field, type /dev/Hmux0.
c) In the Host Name field, type the name of the DNCS host.
b) In the Inband Device Name field, type /dev/Hmux0.
c) In the Host Name field, type the name of the DNCS host.
Example: dncsatm
d) In the QAM BFS Input TSID field, type the value that represents the
output TSID for the BFS MPEG source.
e) In the RF Output TSID for BFS Port field, type the value that
represents the output TSID for the BFS QAM or the BFS port on an
MQAM.
f) In the PSI Interval field, type 80.
g) In the Port field, select 0.
h) In the Bandwidth field, type 38.80.
i) Are you configuring Direct ASI on a DNCS (rather than an RNCS)?
g) In the Port field, select 0.
h) In the Bandwidth field, type 38.80.
i) Are you configuring Direct ASI on a DNCS (rather than an RNCS)?
•
If yes, click DNCS Host.
•
If no, skip to step 5.
5. Click PAT Configuration.
Result: The Inband Data PAT window opens.
6. Click Close on the Inband Data PAT window.
7. Click Save on the Set Up BFS Host window.
Result: The system saves the BFS host configuration.
8. Go to Set Up the BFS Source, next in this appendix.