Cisco Headend System Release 2.5
Appendix C
Direct ASI Installation and Configuration Procedures
110
4004148 Rev C
Check the Status of the ASI Card
Checking the Status of the Direct ASI Card
After installing and configuring the ASI card and installing the ASI package, follow
these instructions to test the status of the card.
1 Type cd /opt/solHmux64 and then press Enter. The /opt/solHmux64 directory
these instructions to test the status of the card.
1 Type cd /opt/solHmux64 and then press Enter. The /opt/solHmux64 directory
becomes the working directory.
2 Type ./vpStatus -d /dev/Hmux0 -P 0 and then press Enter. The system displays
the status of the ASI card.
Example: Your results should look similar to, but not exactly like, the following
example.
Example: Your results should look similar to, but not exactly like, the following
example.
Note: An improperly installed ASI card will yield either no results or results that
clearly show an error.
clearly show an error.
3 Do the results from step 2 show the ASI card to be properly installed?
If yes, go to Restart System Components (on page 111).
If no, call Cisco Services for assistance.