Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Guia Da Instalação
Chapter 2 Theory of Operation
28
OL-29643-02
4-Way Forward Path Signal Routing
GS7000 Node 4-way forward path signal routing functions are described below.
Stage Description
1
1310 nm or 1550 nm optical signals from the headend are applied to
receiver module 1 (and/or modules 2, 3, and 4, if used) in the GS7000
Node.
receiver module 1 (and/or modules 2, 3, and 4, if used) in the GS7000
Node.
2
The receiver module detects the signal on the optical carrier applied to it
and outputs an electrical RF signal to the node Optical Interface Board
(OIB).
and outputs an electrical RF signal to the node Optical Interface Board
(OIB).
3
The RF signals travel across the OIB and cables to the Forward
Configuration Module (FCM). The FCM determines how RF signals
from the different receiver modules are routed to the four independent
forward amplification paths in the RF amplifier module. The 1X4 FCM
splits the RF signals entering it equally between the four forward
amplification paths in the RF amplifier module.
Configuration Module (FCM). The FCM determines how RF signals
from the different receiver modules are routed to the four independent
forward amplification paths in the RF amplifier module. The 1X4 FCM
splits the RF signals entering it equally between the four forward
amplification paths in the RF amplifier module.
4
Each of the forward amplification paths in the RF amplifier module is
composed of one input amplification stage and one interstage
amplification stages in series followed by a power doubler output
amplification stage. This topology provides one driven output port for
each of the forward amplification paths in the RF amplifier module, for a
total of four driven node output ports.
composed of one input amplification stage and one interstage
amplification stages in series followed by a power doubler output
amplification stage. This topology provides one driven output port for
each of the forward amplification paths in the RF amplifier module, for a
total of four driven node output ports.
5
Each of the forward amplification paths in the RF amplifier module also
contains padding, trimming, thermal compensation, equalization, and
filtering circuitry.
contains padding, trimming, thermal compensation, equalization, and
filtering circuitry.
6
Node signal directors are present at two of the nodes forward output
ports and allow the signals at those ports to be redirected to the nodes
auxiliary output ports or split equally between the primary and auxiliary
node output ports. In this way, the node can be configured to have up to
six output ports.
ports and allow the signals at those ports to be redirected to the nodes
auxiliary output ports or split equally between the primary and auxiliary
node output ports. In this way, the node can be configured to have up to
six output ports.