Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Guia Da Instalação

 

 

39 

 

 

 

 
Note: If supplying power to the node through a main output port, a power 
inserter must be installed to inject the AC voltage onto the RF signal. 

6  Use a torque wrench and a 1/2-inch socket to tighten the strand clamp bolts 

from 5 ft-lb to 8 ft-lbs (6.8 to 10.8 Nm). 
Note: A slight tilt of the face of the housing is normal. Cable tension will cause 
the housing to hang more closely to vertical. 

7  Connect the coaxial cable to the pin connector according to the pin connector 

manufacturer’s specifications. 

8  Continue to Fiber Optic Cable Installation (on page 42) and RF Cable 

Installation (on page 50).