Cisco Headend Digital Broadband Delivery System Guia Da Instalação
Chapter 4 Setting Up CMTS or OIT Bridges
70
4017650 Rev C
13 Complete the fields as follows:
For EMM, enter the following values:
–
–
20 for the PID
–
20 for the DNCS ASI PID
–
0.10 Mbps for the Max Data Rate
For the Fast Refresh EMM, enter the following values:
–
–
21 for the PID
–
21 for the DNCS ASI PID
–
1.00 Mbps for the Max Data Rate
For System Messages, enter the following values:
–
–
22 for the PID
–
22 for the DNCS ASI PID
–
0.40 Mbps for the Max Data Rate
For CAT, enter the following values:
–
–
1 for the PID
–
1 for the DNCS ASI PID
–
0.10 Mbps for the Max Data Rate
For Messaging, enter the following values:
–
–
23 for the PID
–
23 for the DNCS ASI PID
–
0.10 Mbps for the Max Data Rate
14 Click OK to enter the parameters in the database.
15 Click Save.
15 Click Save.
Configuring Virtual IP Addresses
Complete the procedure listed in this section to create a virtual IP address.
Important: Before you begin, obtain the hostname and the IP address you want to
use.
1 Open an xterm window on the DNCS and log on as root.
2 Locate the IP address of the TED using the following command:
use.
1 Open an xterm window on the DNCS and log on as root.
2 Locate the IP address of the TED using the following command:
ping –a dncsted
A result similar to the following appears:
dncsted (192.168.1.2) is alive
A result similar to the following appears:
dncsted (192.168.1.2) is alive
3 Run the following command to list all available interfaces:
ifconfig –a
Example: (output may vary significantly)
Example: (output may vary significantly)