Cisco Headend Digital Broadband Delivery System Guia Da Instalação
Chapter 4 SR i4.2.2 Post Upgrade Procedures
74
4036631 Rev B
Check Transport Stream ID Values
In this procedure, confirm that both the Start Transport Stream ID and End
Transport Stream ID values are not both set to 0 (zero). If both values are set to 0,
the system operator will be unable to save a QAM configuration or a VOD stream.
1 From the DNCS Administrative Console, select the DNCS tab and then the
Transport Stream ID values are not both set to 0 (zero). If both values are set to 0,
the system operator will be unable to save a QAM configuration or a VOD stream.
1 From the DNCS Administrative Console, select the DNCS tab and then the
System Provisioning tab.
2 Click Sys Config. The DNCS System Configuration window opens.
3 Click the Advanced Parameters tab.
4 Are both the Start Transport Stream ID and End Transport Stream ID values
3 Click the Advanced Parameters tab.
4 Are both the Start Transport Stream ID and End Transport Stream ID values
set to 0 (zero)?
If yes, go to step 5 and follow the guidelines for setting the transport stream
values ID (TSID).
values ID (TSID).
If no, leave them at their current values and exit from the DNCS System
Configuration window by clicking Cancel.
Configuration window by clicking Cancel.
Note: Only change the values if both fields are set to 0.
5 You were directed to step 5 because both the Start Transport Stream ID and End
Transport Stream ID values were set to 0. Consult with the system operator and
determine what TSIDs were in use on the system prior to the upgrade, and set
the TSIDs accordingly.
In general, follow these guidelines when setting the values:
determine what TSIDs were in use on the system prior to the upgrade, and set
the TSIDs accordingly.
In general, follow these guidelines when setting the values:
If the site you are upgrading uses only our QAM modulators, set the Start
Transport Stream ID and End Transport Stream ID values to 0 and 65535,
respectively.
Transport Stream ID and End Transport Stream ID values to 0 and 65535,
respectively.
If the site you are upgrading uses third-party QAM modulators, in addition
to our QAM modulators, select a range for those third-party modulators. For
example, select 0 and 39999 as the range for our modulators, and 40000 and
65535 as the range for the third-party modulators.
to our QAM modulators, select a range for those third-party modulators. For
example, select 0 and 39999 as the range for our modulators, and 40000 and
65535 as the range for the third-party modulators.
6 If you made an edit in step 5, click Save and close the DNCS System
Configuration window.