Cisco Headend Digital Broadband Delivery System Guia Da Instalação
Chapter 1 Initial Installation of RNCS Software
30
78-4021167-01 Rev D
Enabling TFTP and bootp Services
Note: Do not execute this procedure if TFTP and bootp are not required or desired
on this system.
1 If necessary, open an xterm window on the RNCS as root user.
2 Use a text editor to uncomment (delete the “#” character, if present, at the
1 If necessary, open an xterm window on the RNCS as root user.
2 Use a text editor to uncomment (delete the “#” character, if present, at the
beginning of the line) the following line in the /etc/inet/inetd.conf file.
tftp dgram udp6 wait root /usr/sbin/in.tftpd in.tftpd -s /tftpboot
tftp dgram udp6 wait root /usr/sbin/in.tftpd in.tftpd -s /tftpboot
3 Save and close the file.
4 If the "#" character was removed in the file, type inetconv and then press Enter.
4 If the "#" character was removed in the file, type inetconv and then press Enter.
The system configures the TFTP service.
5 Type svcadm enable svc:/network/tftp/udp6 and then press Enter to enable the
TFTP service.
6 Type svcs svc:/network/tftp/udp6 and then press Enter to verify that the TFTP
service is running.
Example: You should see output similar to the following:
STATE STIME FMRI
online 15:15:14 svc:/network/tftp/udp6:default
Example: You should see output similar to the following:
STATE STIME FMRI
online 15:15:14 svc:/network/tftp/udp6:default
7 Follow these instructions to enable the bootp service.
a As root user, type cd /dvs/lionn/etc and then press Enter.
b Type chmod 4550 bootpd and then press Enter.
b Type chmod 4550 bootpd and then press Enter.
Reboot the RNCS
To activate these network configuration changes, you need to reboot the RNCS.
Follow these instructions to reboot the RNCS.
1 Type shutdown -y -g0 -i6 and press Enter.
2 Log on to the RNCS as root user.
1 Type shutdown -y -g0 -i6 and press Enter.
2 Log on to the RNCS as root user.