Cisco Headend System Release 2.5 Guia Da Instalação
Chapter 2 Upgrade of RNCS Software
58
78-4021167-01 Rev D
38 Complete the following steps to enable ftp, if required, on this system.
Important: The ftp service is required for EAS support on the RNCS. The ftp
service can be enabled if it is preferred over sftp or scp for file transfer to and
from the RNCS.
Note: Enabling the ftp service degrades the security enhancements implemented
Note: Enabling the ftp service degrades the security enhancements implemented
on the RNCS. We recommend that you do not enable the ftp service unless
required.
a As root user in an xterm window on the RNCS, type inetadm –e
a As root user in an xterm window on the RNCS, type inetadm –e
svc:/network/ftp:default and press Enter. The ftp service starts on the RNCS.
b Type svcs ftp and then press Enter to verify that the ftp service is running.
Example: If the ftp service is running, you should see output similar to the
following:
STATE STIME FMRI
online 15:08:44 svc:/network/ftp:default
STATE STIME FMRI
online 15:08:44 svc:/network/ftp:default
39 Complete the following steps verify the status of the tftp and bootp services, if
required, on this system.
Important: The tftp and bootp services are required for Cisco QAMs and QPSKs
Important: The tftp and bootp services are required for Cisco QAMs and QPSKs
and may be used for PCGs.
Note: Enabling the tftp and bootp services degrades the security enhancements
Note: Enabling the tftp and bootp services degrades the security enhancements
implemented on the RNCS. We recommend that you do not enable the tftp and
bootp services unless required.
a As root user in an xterm window on the RNCS, type svcs
a As root user in an xterm window on the RNCS, type svcs
svc:/network/tftp/udp6 and then press Enter to determine whether the TFTP
services are running.
Note: If a message similar to Pattern 'svc:/network/tftp/udp6' doesn't
match any instances appears, the tftp service is not running. Go to Enable the
TFTP and bootp Services (on page Error! Bookmark not defined.) to enable
the tftp services.
b As root user in an xterm window in the ISDS, type siteCmd [SITE_NAME]
lionnControl and then press Enter. The lionnControl menu appears.
c Select option 2.
Note: If output similar to [5 ] Bootp Daemon run(2) inval(7) 0 0 appears, the
bootp service is not running. Go to Enable the TFTP and bootp Services (on
page Error! Bookmark not defined.) to enable the bootp services.