Cisco Headend Digital Broadband Delivery System Guia Do Utilizador
4-6
Front Panel Display Options
4002178 Rev C
Display the Time of Day or Channel Number At Power On
Introduction
The LED Channel Switch option allows subscribers to choose whether the set-top
displays the time of day or the channel number on the LED when the set-top is
powered on. If you do not enable this option, you must select what the set-top
displays when powered on.
Recommended Setting
Enable this option to allow subscribers to choose what is displayed on the front
panel of the set-top when powered on.
Allowing Your Subscribers to Choose What the Set-Top Displays When Powered On
To allow your subscribers to choose whether the set-top displays the time of day or
the channel number when powered on, complete the following steps.
Note: If you want to select what the set-top displays when powered on, see
Note: If you want to select what the set-top displays when powered on, see
Selecting What the Set-Top Displays When Powered On, next in this section.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
Result: The DHCT Configure Prompt window opens.
3.
Select Global.
Result: The Set Up Global DHCT Configuration window opens.
Result: The Set Up Global DHCT Configuration window opens.
4.
Select the General Settings tab.
Result: The General Settings tab appears in the forefront.
Result: The General Settings tab appears in the forefront.
5.
Make sure the option for LED Channel Switch is selected.
Result: When this option is selected, subscribers can choose whether the set-
Result: When this option is selected, subscribers can choose whether the set-
top displays the time of day or the channel number when powered on.
6.
Click Save.
Result: The General Settings menu of the set-top will now display the
Result: The General Settings menu of the set-top will now display the
options for displaying either the time of day or the channel number on the
LED of the set-top at power on.
7.
Click Cancel.
Result: The DHCT Configure prompt opens.
Result: The DHCT Configure prompt opens.