Cisco Headend System Release 2.5 Guia Do Utilizador
Set Up a Single or Redundant SDV Multicast Source
4024447 Rev C
51
OUTPUT
Multicast
–
–
Destination Multicast IP Address: The multicast IP address for the
destination output source that the Netcrypt device is sending video to.
destination output source that the Netcrypt device is sending video to.
–
UDP Port (optional): The destination UDP port that the Netcrypt device
will use when sending the content to the network.
will use when sending the content to the network.
Notes:
–
–
If the INPUT Stream Delivery Type is Unicast, Multicast is automatically
selected for the OUTPUT Stream Delivery Type.
selected for the OUTPUT Stream Delivery Type.
–
When a multicast IP address is used, the UDP port has no operational
value; however, it is beneficial to assign the same UDP port number for
all SDV services to ease network troubleshooting.
value; however, it is beneficial to assign the same UDP port number for
all SDV services to ease network troubleshooting.
8 Click Save.
9 Are you provisioning a secure service?
9 Are you provisioning a secure service?
If yes, refer to Provision a Secure Service (on page 55).
If no, go to step 10.
10 Is your client application running SARA?
If yes, go to Set Up a New SAM Service for an SDV Multicast Source (on
page 56).
page 56).
If no, you have completed the procedures for provisioning the DNCS for
SDV. To complete any further procedures, refer to the documentation that
accompanies your SDV client application.
SDV. To complete any further procedures, refer to the documentation that
accompanies your SDV client application.
Creating a Redundant Source Definition For an Existing Source
Complete the following steps to define a redundant source definition (session) for an
existing SDV source.
1 From the Source List window, select the SDV source, click File, and then select
existing SDV source.
1 From the Source List window, select the SDV source, click File, and then select
Source Definitions. The Source Definitions window opens.
2 From the File menu, select New Digital. The Digital Source Set Up window
opens.
3 For the Session ID field, type the following: 00:00:00:00:02 nnnn, where ―nnnn‖
is the source ID that you entered when you added the source to the Source List.