Cisco Headend System Release 3.2 Manual De Manutenção
Setting Up Download Groups
4024836 Rev D
33
8 Repeat steps 6 and 7 for each DHCT you want to add to the group.
9 Click Save. The new group appears in the list of group descriptions on the
9 Click Save. The new group appears in the list of group descriptions on the
DHCT Groups tab.
Notes:
Notes:
The DHCT should be connected to the network within 2 hours of creating or
adding it to a test group. If the device is not connected within 2 hours, then
the device does not receive a group assignment until the DNCS database
cycles through all in-service devices at a rate of approximately one device per
second. Depending on the number of devices in your system, this process
could take a significant amount of time.
If the device has an Administrative State of Out of Service, the CVT Group ID
message will not be sent by the PassThru process to that device. To check the
Administrative State of the device, see DHCT and CableCARD Module
Administrative Status (on page 38).
10 Confirm that the DHCT was successfully placed into the test group by
displaying the DHCT diagnostic screens and looking at the Group ID field. This
group ID should match the Group ID field displayed on the Set Up a DHCT
Group window on the DNCS.
Note: The Group ID on the DHCT is in hexadecimal format. The Group ID on the
Note: The Group ID on the DHCT is in hexadecimal format. The Group ID on the
DNCS is in decimal format. You might need to convert the Group ID to verify
this step.
11 Do the Group ID values on the diagnostic screen and DNCS match?
If yes, go to Staging SSC DHCTs (on page 75).
If no, contact Cisco Services.
Add the SSC DHCTs to Existing CVT Download Groups
If your download group already exists, follow these steps to add the SSC DHCTs to
the group. If your download group does not already exist, follow the steps in Create
CVT Download Groups (on page 32).
Adding SSC DHCTs to Existing CVT Download Groups
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click Image. The Image List window opens.
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click Image. The Image List window opens.