Cisco Headend Digital Broadband Delivery System Guia De Resolução De Problemas
Chapter 5 Configure EAS Events, Messages, and Tests
50
4024428 Rev B
Configuring Monthly Tests
After you set up the RMT, you must set up the MMM Server. The ISDS uses the
MMM Server to conduct tests of the EAS. Follow these instructions to configure the
MMM Server on the ISDS for the RMT of the EAS.
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click MMM Config. The MMM Configuration List window opens.
4 Double-click configuration Cfg01 to use for the RMT. The Set Up MMM
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click MMM Config. The MMM Configuration List window opens.
4 Double-click configuration Cfg01 to use for the RMT. The Set Up MMM
Configuration window opens with the Force Tune Type tab in the forefront.
5 Click the Message Time tab.
6 In the Description field, type RMT configuration.
7 At your EAS encoder/decoder, locate the Default Duration value.
7 At your EAS encoder/decoder, locate the Default Duration value.
Note: If necessary, refer to the user guide that accompanied your EAS
encoder/decoder.
8 In the Delay Between Repeats field, type a value (in seconds) that equals
[(Default Duration/2) + 1 minute x 60]. Use whole integer division only (drop
the decimal point before adding the +1 minute).
Important: We recommend setting the Delay Between Repeats field to 1860
Important: We recommend setting the Delay Between Repeats field to 1860
seconds for the RMT if the default duration for the RMT is 60 minutes.