Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guia Da Instalação
Chapter 4 Operation
326
4039132 Rev B
To Add Zone Programs Using the Web Interface
Important: Before creating zone programs using the Offered Progs Zones page, you
must set Display Mode to Config on the Configuration page.
must set Display Mode to Config on the Configuration page.
The Offered Progs Zones page displays a list of all offered programs in the switched
tier for each of the zone configurations you have created using the Program Zones
page.
tier for each of the zone configurations you have created using the Program Zones
page.
Note: The following steps refer to Web UI Pages under the Applications.SdvSm
section of the USRM Web UI.
section of the USRM Web UI.
Complete the following steps to add and provision zone programs.
1 On the Configuration page of the USRM Server web interface, set the Display
1 On the Configuration page of the USRM Server web interface, set the Display
Mode parameter to Config.
2 Select the Offered Progs Zones page from the web interface navigation tree. The
Offered Progs Zones page appears as shown below.
3 Enter the new multicast destination IP address in the MulticastDestAddr field in
the row associated with the Program and SourceId of the program it is to replace.
Note:
Note:
If zone programs have source addresses (SrcAddr) or Input UDP port
numbers (InputUdpPort) that differ from the addresses associated with the
(default) SDV Source ID, enter these values into this table.
numbers (InputUdpPort) that differ from the addresses associated with the
(default) SDV Source ID, enter these values into this table.
If the source address fields are left blank, the zone programs use the values
specified in the Offered Programs Formats table; that is, they use the same
sources specified for the (default) SDV program.
specified in the Offered Programs Formats table; that is, they use the same
sources specified for the (default) SDV program.