Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guia Da Instalação
Chapter 3 USRM Web Interface
104
78-4021139-01 Rev D
Parameter
Description
ProtectDelay
Specifies an additional time delay before the switchover.
Upon detecting a failure, the standby will wait this
amount of time to ensure that the primary server has
actually failed.
ProtectDelayStep
In a m:n configuration, one of the m standby servers will
assume control for a failed primary server. The first
standby server connected to the primary typically acts
first. The other standby servers in the list will act if the
servers ahead of it in the list don't act. The
ProtectDelayStep sets the time delay. Each server in the
list delays its action by this amount. The first server in
the list will act first. If it does not, the next server will act
within one ProtectDelayStep. The next server in the list
will act in two ProtectDelayStep periods and so on.
Note: m:n redundancy will be available in a later release.
Note: m:n redundancy will be available in a later release.
Currently, 1:n is supported in supervised mode.
DisplayMode
Sets the web interface display mode, as follows:
Normal - Only populated entries in tables are displayed.
Config - All rows/entries of a table are displayed,
Normal - Only populated entries in tables are displayed.
Config - All rows/entries of a table are displayed,
allowing you to enter values into the displayed rows for
configuration purposes. The server implements dynamic
rows that exist if configured. The Config mode exposes
all rows of a table allowing manual data entry into the
table. This technique is used to create an entry in a table.