Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guia Da Instalação
Chapter 3 USRM Web Interface
286
78-4021139-01 Rev D
S6Server - Configuration Page
The following illustration shows the S6Server - Configuration page.
Parameters
The following table explains the S6Server - Configuration page parameters.
The following table explains the S6Server - Configuration page parameters.
Parameter
Description
DisplayMode
Sets the web interface display mode, as follows:
Normal - only populated entries in tables are displayed.
Config - all rows or entries of a table are displayed,
Normal - only populated entries in tables are displayed.
Config - all rows or entries of a table are displayed,
allowing you to enter values into the displayed rows for
configuration purposes. The server implements dynamic
rows that exist, if configured. The Config mode exposes
all rows of a table, allowing manual data entry into the
table. This technique is used to create an entry in a table.
MpegProgramLow
The USRM assigns MPEG program numbers to programs
when they are activated. This configured parameter sets
the first program number of the range assigned to
services managed by the SdvSm Application. The server
uses the least-recently-used (LRU) algorithm to assign
program numbers. When a program number is released
from use, the time of release is marked for the program.
When the server assigns a new program number, the
release times are used to select the oldest program
number.
MpegProgramHigh
The highest available MPEG program number to be
allocated. The range must be less than 1000 total program
numbers. The high range is adjusted down to enforce this
restriction.