Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guia Da Instalação
Chapter 6 OS Recovery, Software Re-Installation & Upgrade
414
78-4021139-01 Rev D
Replacing the Hard Drive
Follow these steps to replace a failed hard drive in the UCS USRM.
1 Obtain a new replacement hard drive of the same type and size as the hard drive
1 Obtain a new replacement hard drive of the same type and size as the hard drive
that failed.
Note: If a drive is used in the system and removed, the system will refuse to
Note: If a drive is used in the system and removed, the system will refuse to
reuse that same drive, even if the drive is still working. The replacement drive
must be “new” (unformatted).
2 Remove the failed hard drive as follows:
a Press the release button (1) to expose the ejector lever (2).
b Pull the ejector level (2) toward you.
c Pull the hard drive sled from the drive bay.
b Pull the ejector level (2) toward you.
c Pull the hard drive sled from the drive bay.
3 Install the new hard drive as follows:
a Press the release button (1) on the new hard drive to expose the ejector lever
(2).
b With the ejector lever (2) open, push the sled into the drive bay until you feel
the drive stop against the backplane.
c Press the ejector lever flat until the lock clicks into space.
4 Confirm that the system accepts the new hard drive.
Note: The solid yellow warning light on the drive begins to flash after a few
seconds. If the warning light stays lit for more than 1 minute, repeat this
procedure with a new drive. Also double-check the drive make and model to
ensure that you are using the correct replacement part.
5 Confirm that the mirroring process completes successfully.
Note: The system continues to beep while the drive is being mirrored; this
process can take several hours. After mirroring is complete, the flashing yellow
light and the warning beep both stop.