Cisco Cisco FastHub 412M 10 100 Repeater

Refer to the online FastHub 400 10/100 Series Command Reference for information about accessing 
the CLI. See the 

 section of this document for information about 

locating this document through Cisco.com.

Use the CLI delete nvram command to reset either or both management hubs to their default values. 

Refer to the online reference FastHub 400 10/100 Series Command Reference for more information 
about this command.

The management hub that is powered on first becomes the new M1 hub in the stack because the hub 
with the longest up time is by default the M1 hub. 

If you delete the NVRAM configuration settings for one management hub and not the other, be sure 
to power on the management hub with the deleted configuration first. This prevents the redundant 
management hub from copying its saved configuration to the hub whose configuration you just 
deleted.

This section describes resolved caveats in the FastHub 400s.

This problem was resolved in release v.1.00.04:

CSCdr79923

An enable password is no longer limited to less than eight characters. 

This problems was resolved in release v.1.00.03:

CSCdr17179

Using Cisco Discovery Protocol (CDP) with a FastHub 400M no longer occasionally locks the 
console. 

These publications provide more information about the FastHub 400 models:

FastHub 400 10/100 Series Command Reference (online only)

FastHub 400 10/100 series Hub Manager online help