Cisco DNCS System Release 2.7 3.7 4.2 Guia Do Desenho

Página de 110
4000358 Rev B 
Setting Up a Home Network 
6-5 
Connect the DOCSIS-Capable DHCT to a PC Through a Hub,
 Continued 
 
4. 
Verify that the subscriber has completed the configuration properly by 
completing the following steps: 
a)  Verify that the subscriber is using a straight-through Ethernet cable. 
b)  Verify that the cable is plugged in on both sides. 
c)  Verify that the DOCSIS-capable DHCT is powered on. 
d)  Verify that the hub port in use is in non-uplink mode. (If applicable, ask 
the subscriber to try toggling the port mode using the Uplink button on 
the hub until the link light appears.) 
5. 
Does the link light appear now? 
• 
If yes, go to step 6. 
• 
If no, call the cable service provider for assistance. 
Important:  If the link light does not appear, there is a problem in the 
configuration. Call the cable service provider. 
6. 
Connect a PC to another non-uplink port of the hub. 
7. 
Power on or reboot the PC. 
Result:  A link light appears on the hub port to which the PC is connected. 
8. 
Does the link light appear on the hub? 
• 
If yes, go to step 10. 
• 
If no, verify that the subscriber has completed the configuration properly 
by completing the following steps: 
a)  Verify that the subscriber is using a straight-through Ethernet cable. 
b)  Verify that the cable is plugged in on both sides. 
c)  Verify that the PC is powered on. 
d)  Verify that the hub port in use is in non-uplink mode. (If applicable, 
ask the subscriber to try toggling the port mode using the Uplink 
button on the hub until the link light appears.)