Cisco DNCS System Release 2.7 3.7 4.2 Guia Do Utilizador
Chapter 3 Generating Reports
18
4038579 Rev B
Report Title
Description
Filter Options
Netcrypt Report
Data listed: All Netcrypt™ servers in
the DNCS database and their status.
Note: This report only appears if
Note: This report only appears if
Netcrypt is enabled on the DNCS.
Non-Responding DHCTs-
Lost Connection Report
Data listed: DHCTs with an
administrative status of In Service-Two
Way which have an IP address, but
whose operational status is
“Unknown,” “MAC initialization
failed,” or “DSMCC boot failed.”
Normal condition: Queries the DNCS
Normal condition: Queries the DNCS
database to identify DHCTs
configured for two-way service that
have lost a previous two-way
connection.
TSID List
Transport Stream ID
Data listed: Lists transport stream IDs
Data listed: Lists transport stream IDs
(TSIDs) used by QAMs from Cisco and
other vendors.
Normal condition: Queries the
Normal condition: Queries the
database to identify all TSIDs that have
been used in the system.
*This situation should occur infrequently, if at all, and could indicate that some sort of DNCS database corruption
has occurred. Try to open the applicable DNCS Administrative Console GUIs to ensure that the data is intact for a
particular device.
About SNMP Poll Reports
The SNMP Poll Reports collect data by issuing up to three SNMP poll requests to
The SNMP Poll Reports collect data by issuing up to three SNMP poll requests to
each candidate DHCT (set-top).
Note: The term candidate DHCTs refers to DHCTs in the DNCS database that have an
Note: The term candidate DHCTs refers to DHCTs in the DNCS database that have an
associated MAC address, IP address, QPSK Modulator, and QPSK Demodulator,
along with an administrative status of In Service-Two Way. If a DHCT listed in the
DNCS database does not meet all of these criteria, it will be excluded from the
SNMP Poll Report. The SNMP poll request determines the current two-way
communication ability of each DHCT.
When the SNMP Poll Report is run, each candidate DHCT is polled (this is also
When the SNMP Poll Report is run, each candidate DHCT is polled (this is also
called an SNMP "get" request). This SNMP poll collects all of the data necessary for
generating the four SNMP Poll reports. The SNMP Poll reports are different views
into the data collected.