Cisco DNCS System Release 2.7 3.7 4.2 Guia Da Instalação
Appendix C
Recommended Frequencies for Improved CVT Download Performance
94
78-4003052-01 Rev G
Frequency Plan Recommendations
Using the frequencies in this appendix vastly improves the speed and performance
of the initial staging process.
After a DHCT has been successfully downloaded using the CVT download method,
After a DHCT has been successfully downloaded using the CVT download method,
the DHCT retains the frequency of the carousel for subsequent downloads and,
therefore, does not search for the frequency again.
What Are the Recommended Frequencies?
Cisco strongly recommends that you configure at least one QAM modulator to use
one of the recommended frequencies shown in the following table.
Channel HRC
Frequencies
IRC and STD
Frequencies
36
295.75 MHz
297.0 MHz
61
445.75 MHz
447.0 MHz
77
541.75 MHz
543.0 MHz
79
553.75 MHz
555.0 MHz
101
655.75 MHz
657.0 MHz
Important!
These are the channels and frequencies that the DHCT checks first during
staging. If you use other frequencies, then the DHCT is forced to scan all possible
frequencies until it finds the correct frequency.
Although additional scanning increases the time needed to download software,
the CVT download method operates at all STD, IRC, and HRC frequencies.
Because the CVT information is loaded into all QAMs, or those selected as
staging bridges, the selected QAM does not need to be the QAM used to carry
the BFS sessions. You may select from any of the QAMs configured in your
network.