Cisco DNCS System Release 2.7 3.7 4.2 Guia Da Instalação

Página de 152
 
 
Phase One Checklist 
78-4003052-01 Rev G 
17 
 
Phase One Checklist 
Use the checklist in this chapter to check off each task as you complete it. When you 
finish this phase, save a copy of the checklist and all of the results from any tests that 
you run in the event that the installation process fails during a later phase.  
 
CAUTION: 
You must complete each task in this checklist before you can proceed to the 
next task. Otherwise, you risk a failed installation, which could disrupt 
service to your subscribers. 
Where necessary, the remaining sections of this chapter provide further detail to 
help you complete each task in this checklist. 
 
This is hidden text to keep the box for number 1 intact. Do not delete this line. 
1  Choose one of the following options: 
 
If you are upgrading existing DHCTs on a two-way system, reboot, wait for 
the clock, power on an operational (in two-way mode) test DHCT, and do the 
following: 
– 
Verify that all third-party applications and channels are available and 
function as expected. 
– 
Check Page 2 of the diagnostic screen to verify that the boot status is 
READY. 
 
If you are loading code for new devices (for example, for a new DHCT type 
or revision), go to step 6. 
2  Run the listQpsk utility as described in the CoolTools Utilities User's Guide
Record the percentage of DHCTs that are signed on to your network in listQpsk 
Results (on page 19). 
3  Run the updateOUI utility using the -r option command and then run the 
updateOUI command with no options. 
4  Run the doctor -av utility as described in the DBDS Utilities Version 5.1 
Installation Instructions and DNCS Utilities User’s Guide
5  Record the results in 
Key Doctor Results (on page 19). If the results of the doctor 
utility show any unexpected errors, then you should correct these errors before 
proceeding with the download process. 
6  Delete unused DHCT types from the DHCT type list window. 
7  Run the listOSM utility. Delete the unused VER files and their associated ROM 
files from the DHCT OS List GUI. 
8  Run the listCVT utility. Delete the unused ROM files from the Image List GUI. 
9  If you are loading software to support a new DHCT or CableCARD module, load 
the EMM CD for the new device type. This step adds the type, model, and 
revision information to the system.