Cisco DNCS System Release 2.7 3.7 4.2 Guia Da Instalação

Página de 152
 
Chapter 2    Phase One - Perform Pre-Upgrade Checks 
 
 
 
32 
78-4003052-01 Rev G 
6  Type y and press Enter to start the installation. 
Note: The installation should take less than 30 seconds. 
7  Did a message appear indicating that the installation was successful? 
 
If yes, go to step 8. 
 
If no, contact Cisco Services. 
8  Use the UNIX rm -rfi command to remove the following file and directory: 
 
SAIresapp.tar (file) 
 
SAIresapp (directory) 
Example: Type rm –rfi SAI* and press Enter
Result: A confirmation question message appears asking you to confirm the 
removal. 
9  Type Yes and press Enter
10  Are there additional tar files in the directory you need to install? 
 
If yes, repeat steps 4 through 7 until you have installed all the necessary files. 
 
If no, go to Install the OS Check Table (Optional) (on page 34). 
 
Installing the Software from a CD 
Complete the following steps to install the application platform software release 
onto the DNCS. 
Notes:  
 
System components do not have to be shut down to install the software. 
 
This procedure assumes the install_pkg package installer is located in the 
/usr/sbin/ directory. 
1  Insert the CD into the CD-ROM drive on the DNCS. The system automatically 
mounts the CD to /cdrom/cdrom0 within 30 seconds. 
2  Type df -n and press Enter. A list of the mounted file systems appears. If /cdrom 
displays in the output, then this confirms that the system correctly mounted the 
CD. 
3  From the xterm window where you are logged on as root, type 
cd /cdrom/cdrom0 and press Enter
4  Type /usr/sbin/install_pkg SAIresapp and press Enter
Results: 
 
The system lists the packages that will be installed. 
 
A confirmation message appears asking you to confirm that you want to 
proceed with the installation. 
5  Type y and press Enter to start the installation. 
Note: The installation should take less than 30 seconds.