Cisco DNCS System Release 2.7 3.7 4.2 Guia Da Instalação
Chapter 3 Phase Two - Test New Software
42
78-4003052-01 Rev G
Phase Two OSM Checklist
Use the checklist in this chapter to check off each task as you complete it. When you
finish this phase, save a copy of the checklist and all of the results from any tests that
you run in the event that the installation process fails during a later phase.
CAUTION:
You must complete each task in this checklist before you can proceed to the
You must complete each task in this checklist before you can proceed to the
next task. Otherwise, you risk a failed installation, which could disrupt
service to your subscribers.
Where necessary, the remaining sections of this chapter provide further detail to
help you complete each task in this checklist.
OSM Installation Checklist
1 Unassign the TOC files for the DHCT types you are upgrading that use the OSM
download method.
2 Remove the unused ver and split image files from the OS List.
3 Install the application platform software release onto the BFS.
4 Download OSM software to the test DHCTs.
5 Verify that the test DHCTs operate as expected by checking the following:
3 Install the application platform software release onto the BFS.
4 Download OSM software to the test DHCTs.
5 Verify that the test DHCTs operate as expected by checking the following:
Check Page 5 of the diagnostic screens on the test DHCT to verify that the
software version is correct.
Check Page 2 of the diagnostic screens to verify that all boot statuses are
correct.
Verify that the IPG can display current and future data.
Verify that all third-party applications are available and function as expected.
Verify that you can successfully purchase and view a PPV or IPPV event on
the test DHCT.
6 When you finish the OSM portion of Phase Two, do one of the following:
If you have DHCTs to test for CVT, go to Phase Two CVT Checklist (on page
If you do not have DHCTs to test for CVT, go to Phase Three - Install New
Software (on page 63).