Cisco DNCS System Release 2.7 3.7 4.2 Referências técnicas

Página de 16
4011319 Rev C 
 
11 
 
 
Configure Unencrypted Transport Streams 
 
20  Repeat steps 13 through 19 until all required non-Cisco source definitions have 
been built for this source. 
21  From the Source Definition List window, select File and choose Close to exit the 
Source Definition List window. 
22  Repeat steps 4 through 21 until all Sources have been updated or created. 
23  From the Source List, note the Source ID for the new sources. You will need these 
when building SAM services. Then, select File and choose Close to exit the 
Source List. 
24  Now that you have added sources and source definitions for each session to be 
carried by the clear QAMs, you must reboot the siManager process to have these 
additions take effect. 
Important: Refer to the Digital Network Control System Online Help for your 
system for detailed procedures on rebooting the siManager process. 
25  Select from one of the following options: 
 
If you created new sources you must do the following: 
– 
Create SAM services for each of the new non-Cisco digital sources you 
just created. 
– 
Add the new SAM services to the channel map(s). 
– 
Create Interactive Program Guide (IPG) entries for each of the new 
services. 
Important: Refer to the Digital Network Control System Online Help for your 
system for detailed instructions. 
 
If you only modified existing sources, go to step 26. 
26  To verify that you can view the new services, use a DHCT to tune to the new 
services. 
27  Can you view the new services? 
 
If yes, go to Deleting Existing Mirror QAMs (on page 11). 
 
If no, call Cisco Services. 
 
Deleting Existing Mirror QAMs 
After creating new or modifying existing sources, we recommend that you clean up 
your system configuration by deleting your existing mirror QAMs.