Cisco DNCS System Release 2.7 3.7 4.2 Referências técnicas

Página de 16
 
4011319 Rev C 
 
Configure Unencrypted Transport Streams 
 
Before You Begin 
Consider the following factors as you complete the procedures in this section: 
 
You must configure the QAM using the Set Up QAM window on the DNCS. You 
must do this before the QAM is able to boot. 
Note: In earlier software releases, you were required to use the /etc/bootptab 
file to configure the QAM. This is no longer required. If the /etc/bootptab file 
contains any QAMs, you should delete them from the /etc/bootptab file. 
 
This procedure allows the QAM to pass everything that it receives on the ASI 
input through to the RF output.  
Because the DNCS will not be used to build sessions, be careful that the data rate 
on the ASI input to the QAM does not exceed the output capacity of the QAM 
(27 Mbps for 64 QAM or 38 Mbps for 256 QAM). 
 
Beginning with CAQAM 2.5.1 and MQAM 2.6.11, the passthru setting is stored 
in non-volatile memory (NVM). If you are using CAQAM 2.5.1 or MQAM 2.6.11, 
you do not have to re-enable passthru mode whenever the QAM loses power. 
However, earlier versions of the QAM software did not store the passthru setting 
in NVM.  Because this setting is now persistent through reboots, an 
uninterruptible power supply is no longer required. 
In order to set up non-Cisco digital sources, you must know the program numbers 
for content passed through the QAM. 
Set Up the Clear QAM 
Complete this process to set up the clear QAM. 
1  Configure the QAM on the DNCS as if it were a standard QAM. 
Important:  
 
Do not assign this QAM to a service group. You cannot use this QAM to set 
up broadcast or VOD sessions. The QAM will not allow you to set up 
sessions when it is in passthru mode. 
 
Be sure that you record the frequency and modulation type of this QAM for 
later use. You will need this information in Setting Up Non-Cisco Digital 
Sources
 (on page 7). 
2  Boot the QAM so it can fully load the appropriate software and receive 
provisioning information from the DNCS. 
3  Connect a PC terminal to the craft port on the back panel of the QAM being 
configured. Use a standard RS-232 cable with a DB9 connector.