Cisco Cisco StadiumVision Director Manual De Manutenção
© 2011 Cisco Systems, Inc. All rights reserved.
Page 32 of 40
Showing, Hiding, and Displaying the Initial SWF Message
Send the Show Init and Hide Init Swf commands to display or hide the Init SWF
application on the DMP. Send the Initial SWF Message command display the
specified message in the Init Swf application on the DMP. Message text is specified
in the appOptionsXML variable.
application on the DMP. Send the Initial SWF Message command display the
specified message in the Init Swf application on the DMP. Message text is specified
in the appOptionsXML variable.
Auto Registering and Provisioning a DMP
Use the Auto Registration commands in the
Device Configuration drawer to change the
DMP state and provision the DMP for auto
registration.
Device Configuration drawer to change the
DMP state and provision the DMP for auto
registration.
Auto Registration
Change DMP State
Changes the state of the selected DMPs. Accepted values are
„Not Ready‟ or „Ready‟
or Production‟.
Provision DMP
Provisions a DMP for use in StadiumVision. This command will send the Initial
Config, Upgrade Firmware, Stage Flash Template and the Global DMP Settings
command on selected DMPs. Executing this command will change the DMP state to
"Not Ready". Upon successful completion the DMP state will be set to "Ready".
Config, Upgrade Firmware, Stage Flash Template and the Global DMP Settings
command on selected DMPs. Executing this command will change the DMP state to
"Not Ready". Upon successful completion the DMP state will be set to "Ready".
Changing the DMP State for Auto Registration
The Provision DMP operation will be skipped if the DMP is in
the „Ready‟ or „In
Production‟ state. To change the state of the selected DMPs to „Not Ready‟ or „Ready‟
or „Production‟ set the auto provisioning and auto registration values for the DMP
State command to
or „Production‟ set the auto provisioning and auto registration values for the DMP
State command to
„true‟.
Provisioning a DMP
When you send the Provision DMP command, the Provision DMP Operation begins.
The Provision DMP Operation is a collection of Dashboard commands that are sent in
sequence to provision the DMP. The commands use dependency checking. That is,
the commands are executed only if the previous command was successful. Table 4
defines the sequence and purpose of the commands that are executed for the
Provision DMP operation.
The Provision DMP Operation is a collection of Dashboard commands that are sent in
sequence to provision the DMP. The commands use dependency checking. That is,
the commands are executed only if the previous command was successful. Table 4
defines the sequence and purpose of the commands that are executed for the
Provision DMP operation.
The Provision DMP operation can be initiated automatically or manually. While a DMP
is being provisioned, it transitions through three states:
is being provisioned, it transitions through three states:
Not Ready -> Ready -> Production
Not Ready: The DMP is registered in SV Director but has not been
provisioned.