Cisco Cisco OptoStar II 1550nm Transmitter Guia Da Instalação
Operating using ICIM LCD, Continued
Sub-Menu 1 -- Optical Input Information
The illustration below shows sub-menu 1 of the OptoStar II 1550 nm optical
amplifier module - Optical Input Information:
amplifier module - Optical Input Information:
The optical input information sub-menu includes options to set the optical input
power alarm threshold and a reading of the optical input power.
The default range of the optical input power alarm threshold is -5.0 dBm ~ 10.0
dBm, with 0.1 dB step. The cursor stays in the “Low” field by default.
power alarm threshold and a reading of the optical input power.
The default range of the optical input power alarm threshold is -5.0 dBm ~ 10.0
dBm, with 0.1 dB step. The cursor stays in the “Low” field by default.
•
To configure the lower limit of optical power alarm threshold
1. Press SET button to start the configuration;
2. Press ▲▼ buttons to change the value, and press SET button to confirm;
3. Press ► button to move the cursor to “Set”;
4. Press SET button to save the configuration.
2. Press ▲▼ buttons to change the value, and press SET button to confirm;
3. Press ► button to move the cursor to “Set”;
4. Press SET button to save the configuration.
•
To configure the upper limit of optical power alarm threshold
1. Press ▼ button to leave the cursor in the “High” field;
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set”;
5. Press SET button to save the configuration.
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set”;
5. Press SET button to save the configuration.
Continued on next page
OL-29666-02
Operation
3-7