Cisco Cisco OptoStar II 1310nm Transmitter Guia Da Instalação
Installing/Removing the Modules
To Install the Module
Install the ICIM module and power supply module first. See Cisco OptoStar II
Intelligent Communications Interface Module (ICIM) Installation and Operation
Guide, part number: OL-29660 and Cisco OptoStar II Chassis (CH) and Power
Supply (PS) Installation and Operation Guide, part number: OL-29659 for
details.
Now you may start to install the OptoStar II 1550 nm optical amplifier module.
Connect it to the rear panel connector of the chassis. The following illustration
shows the installation steps of single-slot panel (1-in, 1-out) and double-slot panel
(1-in, 8-out) optical amplifier module.
Intelligent Communications Interface Module (ICIM) Installation and Operation
Guide, part number: OL-29660 and Cisco OptoStar II Chassis (CH) and Power
Supply (PS) Installation and Operation Guide, part number: OL-29659 for
details.
Now you may start to install the OptoStar II 1550 nm optical amplifier module.
Connect it to the rear panel connector of the chassis. The following illustration
shows the installation steps of single-slot panel (1-in, 1-out) and double-slot panel
(1-in, 8-out) optical amplifier module.
1. Select Slot 4 – Slot 17.
2. Inspect all pins on the rear panel and confirm that they are not bent.
3. Hold module vertically with module front towards you.
4. Align the rib on lower side of the module with a guide slot in the chassis and
2. Inspect all pins on the rear panel and confirm that they are not bent.
3. Hold module vertically with module front towards you.
4. Align the rib on lower side of the module with a guide slot in the chassis and
align top rib with matching guide slot in the top of the chassis.
Continued on next page
2-4
Installation
OL-29666-02