Cisco Cisco OptoStar II 1550nm EDFA Guia Da Instalação
Console-Module Control Interface, Continued
Basic Parameter
The table below lists the basic parameters of the OptoStar II forward receiver
module.
module.
Basic Parameter
Description
Module Name and Firmware
Version
Shows the module name and its firmware
version
Optical Input Power
Shows optical input power (dBm)
Module Temperature
Shows the current module temperature (°C)
S/N
Shows module serial number
Rack ID
Shows the ID of the rack where the chassis
is placed
Slot ID
Shows the ID of the slot where the module
is placed
Alarm Code
Shows the current module alarm code
Move the cursor to the question mark at the
Move the cursor to the question mark at the
right side of the Alarm Code to show the
alarm list as below:
Setup Parameters
The table below lists the setup parameter of the OptoStar II forward receiver
module.
module.
Setup Parameters
Description
Factory Default
Optical Alarm
Threshold
Shows/sets optical alarm upper
limit and lower limit
Lower limit: -4.0 dB
Upper limit: +4.0 dB
Upper limit: +4.0 dB
Gain Control Mode
Selection
Shows/sets AGC or MGC gain
control mode
AGC mode (MGC
gain setting is 0 dB)
Alarm ON/OFF
Shows/sets module alarm status:
ON/OFF
Alarm status: ON
OL-29664-05
Operation
3-29