Cisco Cisco OptoStar II 1550nm Transmitter Guia Da Instalação
Installing/Removing the Modules, Continued
To Remove the Module
1. Remove the fiber connector from the front panel of the module, and cover the
fiber and module connector with dust caps immediately.
2. Loosen the mounting screws on lower front panel of the module by hand or
screwdriver, to release the module from the chassis.
3. Pull the module slightly to unseat the connector.
4. Hold the module and gently remove it from the chassis.
4. Hold the module and gently remove it from the chassis.
Note: Do not use the mounting screws as a handle when removing the module.
Follow the steps as shown in the following illustration.
Follow the steps as shown in the following illustration.
OL-29670-02
Installation and Configuration
2-5