Cisco Cisco OptoStar II 1310nm Transmitter Guia Da Instalação
Operating using ICIM LCD, Continued
Sub-Menu 3 -- Channel Load
The illustration below shows sub-menu 3 of the OptoStar II forward driver
amplifier module - Channel Load.
amplifier module - Channel Load.
Configuration range of the channel number: The range of analog channel number
is 0 to 110; the range of QAM channel number is 0 to 153; and the range of delta
level is from 0 to 10 dB (included).
is 0 to 110; the range of QAM channel number is 0 to 153; and the range of delta
level is from 0 to 10 dB (included).
•
In NTSC system, the recommended analog channel number is set to 78; the
recommended QAM channel number is 75; and the recommended delta level is
6. 0 dB for delta level.
recommended QAM channel number is 75; and the recommended delta level is
6. 0 dB for delta level.
•
In PAL D/K system, the recommended analog channel number is set to 59; the
recommended QAM channel number is 53; and the recommended delta level is
6. 0 dB for delta level.
recommended QAM channel number is 53; and the recommended delta level is
6. 0 dB for delta level.
Please enter the correct analog, QAM channel numbers and delta level based on
the actual application, otherwise the RF input value of the forward driver
amplifier module will be inaccurate. If the digital signal consists of the signal
from the broadcast RF input port and the narrowcast RF input port, the number
of the QAM channel equals to the number of the input signal channel at the
broadcast RF input port plus the number of the input signal channel at the
narrowcast RF input port.
The default settings of channel load are: 59 for analog channel number; 53 for
QAM channel number; and 6. 0 dB for delta level. The cursor stays in the “Analog
Number” field by default.
the actual application, otherwise the RF input value of the forward driver
amplifier module will be inaccurate. If the digital signal consists of the signal
from the broadcast RF input port and the narrowcast RF input port, the number
of the QAM channel equals to the number of the input signal channel at the
broadcast RF input port plus the number of the input signal channel at the
narrowcast RF input port.
The default settings of channel load are: 59 for analog channel number; 53 for
QAM channel number; and 6. 0 dB for delta level. The cursor stays in the “Analog
Number” field by default.
Continued on next page
OL-29667-02
Operation
3-11