Cisco Cisco OptoStar II Driver Amplifier Guia Da Instalação

Página de 89
Before You Begin 
This section introduces the procedures to operate the OptoStar II NMS. 
Before You Begin 
• 
Database server 
• 
Web server 
• 
Polling server 
Start 
1.  Make sure that the fiber and RF cables of relevant modules of the OptoStar II 
platform are connected. 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and other modules will initialize for 
about 5 seconds, and the ICIM will start loading for about 25 seconds. 
3.  When the device initialization is complete, connect to the Ethernet with the 
RJ-45 connector on the rear panel of the ICIM. Connect the PC to the Ethernet. 
The illustration below shows the connection method. 
 
4.  Log into the OptoStar II NMS system. 
 
 
 
 
 
3-2 
 
Operation 
OL-29665-03