Cisco Cisco OptoStar II Driver Amplifier Guia Da Instalação

Página de 71
Installing/Removing the Modules, Continued 
To Remove the Module
 
1.  Remove the fiber connector from the front panel of the module, and cover the 
fiber and module connector with dust caps immediately. 
2.  Remove the RF cable from the rear panel of the module. 
3.  Loosen the mounting screws on lower front panel of the module by hand or 
screwdriver, to release the module from the chassis. 
4.  Pull the module slightly to unseat the connector. 
5.  Hold the module and gently remove it from the chassis.
 
Note: Do not use the mounting screws as a handle when removing the module. 
Follow the steps as shown in the following illustration.
 
 
 
 
 
 
OL-29663-03 
Installation 
2-5