Cisco Cisco OptoStar II 1550nm EDFA Guia Da Instalação
Introduction
Description
The OptoStar II reverse receiver module uses a standard 19-in OptoStar II chassis.
The flexibility of the platform is greatly improved by the fact that a single chassis
can hold both reverse receiver modules and other OptoStar II modules. 14 reverse
receiver modules can be placed in one standard 3 RU OptoStar II chassis. Each
reverse receiver module has four independent optical receiver channels and four
RF output ports. With an additional combiner module, it offers a working mode
of four input signals and one output signal.
The flexibility of the platform is greatly improved by the fact that a single chassis
can hold both reverse receiver modules and other OptoStar II modules. 14 reverse
receiver modules can be placed in one standard 3 RU OptoStar II chassis. Each
reverse receiver module has four independent optical receiver channels and four
RF output ports. With an additional combiner module, it offers a working mode
of four input signals and one output signal.
Features
•
5 to 200 MHz of bandwidth
•
Each module has four independent reverse optical receive channels
•
With an additional combiner module, it combines four RF signals into one
output signal
output signal
•
LED on the front panel indicates the working status of the module, with RF
output test point
output test point
•
Automatic Gain Control (AGC) and Manual Gain Control (MGC) available
•
Intelligent Communications Interface Module (ICIM) provides various
configuration and control options
configuration and control options
-
Local monitoring and control on the ICIM LCD screen
-
Local monitoring and control with ICIM Mini-USB interface connecting to the
console on PC
console on PC
-
Remote status monitoring (SNMP) with ICIM RJ-45 interface
•
Firmware is upgradeable
•
Hot-swap capability
Block Diagram
The following block diagram shows the signal pathway of the OptoStar II reverse
receiver module.
receiver module.
OL-29663-03
Introduction
1-3