Cisco Cisco Prisma II EDR Receiver Guia Da Instalação
Connecting the RF Cables to the Chassis
78-4023013-01 Rev C
17
Connecting the RF Cables to the Chassis
To Connect RF Cables for Each Module
Complete the appropriate procedure below to connect RF cables for the module.
Note: These procedures assume that the chassis is mounted in a rack.
Note: These procedures assume that the chassis is mounted in a rack.
Standard Prisma II Chassis
1 Attach a 75-ohm RF cable to the appropriate RF source.
2 At the front/rear of the chassis, locate the RF ports.
1 Attach a 75-ohm RF cable to the appropriate RF source.
2 At the front/rear of the chassis, locate the RF ports.
Note: RF ports are located on the front of the front access chassis.
3 Attach the other end of the RF cable to Port A connector (RF IN) of the
corresponding slot where the module is to be installed. This is the RF input
connection.
4 If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis.