Cisco Cisco UCS B440 M2 High-Performance Blade Server Ficha De Dados

The 6200 fabric interconnect series supports SFP+ Ethernet transceivers, SFP transceivers, and SFP Fibre 
Channel transceivers.

The high bandwidth of 10-Gigabit Ethernet poses challenges to transmissions that are met by the 
transceiver and cabling options supported by the Cisco UCS 6200 platform.

The enhanced SFP+ 10-Gigabit Ethernet transceiver module is a bidirectional device with a transmitter and 
receiver in the same physical package. It has a 20-pin connector on the electrical interface and duplex LC 
connector on the optical interface. 

 lists the supported SFP+ transceiver options.

The SFP 1-Gigabit Ethernet transceiver module is a bidirectional device with a transmitter and receiver in 
the same physical package. 

 lists the supported SFP transceiver options.

Copper cables are available for use with the 10-Gigabit Ethernet SFP+ module. 

 lists the 

supported cable options.

On the Cisco UCS 6200 platforms, you can use an innovative Twinax copper cable that connects to standard 
SFP+ connectors for in-rack use. For longer runs, you can use an optical cable.

For in-rack or adjacent-rack cabling, the Cisco UCS 6200 platform supports SFP+ direct-attach 10-Gigabit 
Ethernet copper, which integrates transceivers with Twinax cables into an energy efficient, low-cost, and 
low-latency solution. SFP+ direct-attach 10-Gigabit Twinax copper cables use only 0.1 watts of power per 
transceiver and introduce only approximately 0.25 microsecond of latency per link.

For longer cable runs, the Cisco UCS 6200 platform supports multimode, short-reach optical SFP+ 
transceivers. These optical transceivers use approximately 1 W per transceiver and have a latency of less 
than 0.1 microsecond.

The Cisco UCS 6200 series fabric interconnects support multimode 850nm 4 Gbps and 8 Gbps SFPs with 150m 
reach (see 

).