Cisco Cisco OptoStar II 1310nm Transmitter Guia Da Instalação
Installing/Removing the Modules, Continued
To remove the Module
1. Remove the fiber connector from the front panel of the module, and cover the
fiber and module connector with dust caps immediately.
2. Remove the RF cables from the rear panel of the module.
3. Loosen the mounting screws on lower front panel of the module by hand or
3. Loosen the mounting screws on lower front panel of the module by hand or
screwdriver, to release the module from the chassis.
4. Pull the module slightly to unseat the connector.
5. Hold the module and gently remove it from the chassis
Note: Do not use the mounting screws as a handle when removing the module.
Follow the steps as shown in the following illustration.
5. Hold the module and gently remove it from the chassis
Note: Do not use the mounting screws as a handle when removing the module.
Follow the steps as shown in the following illustration.
OL-29662-03
Installation
2-5