Cisco Cisco OptoStar II Driver Amplifier Guia Da Instalação

Página de 66
Installing the Chassis 
Mount the empty chassis in the equipment rack, using pan or round head screws 
and washers in the four front panel corner mounting locations. This enables a 
secure mount of the unit on the chassis. You must use screws matching your rack. 
 
Chassis Location in Rack 
The chassis can be placed anywhere within the rack. Hot air discharged from 
other equipment must not be directed at the chassis front panel. Dust from the 
surrounding environment should not be ingested in the input airflow. The chassis 
can be mounted without any gap, directly above or below another chassis or 
other equipment that does not discharge hot air directly at the front panel of the 
chassis. 
 
Operating Temperature 
Make sure the unit is operated in a temperature and humidity-controlled 
environment. See the temperature specifications in the datasheet. 
 
Note: The maximum operating ambient temperature is 50°C (122°F). 
 
Long-term reliability is best obtained with consistently cool environments. Never 
place a unit near a heat source. Do not install a unit in areas of high humidity or 
where there is any chance of water or condensation dripping into or on the unit. 
 
Verify Rack Dimensions 
It is important to verify the rack dimensions to guarantee proper installation of 
the chassis. The minimum Telco rack dimensions needed for installation are as 
follows. 
 
The chassis weighs 6. 6 kg and can be installed into a 19-in. rack. The maximum 
width of the chassis is 481 mm, and the width without mounting ears is 437 
mm.   
 
 
 
 
OL-29662-03 
Installation 
2-3