Cisco Cisco Prisma II EDR Receiver Guia Da Instalação
2-2
Installation
78-748704-01 Rev C
Prepare for Installation
Introduction
Before you begin, make sure the module is in good condition and that you have the
tools and equipment listed below.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. If you find any damage,
contact Cisco Services.
Required Equipment and Tools
The following table shows the equipment and tools required to install the module.
You need . . .
To . . .
a chassis with power supply
provide housing, power, and input/output
connections to the module.
two optical cables with connectors carry optical input signals.
four 75-ohm RF cables with F-type
four 75-ohm RF cables with F-type
connectors
carry RF output signals.
3/8-in. flat-blade screwdriver
secure the module in the chassis.
a 7/16-in. open-end wrench
secure RF cables to the connectors on the
chassis.