Cisco Cisco Prisma II EDR Receiver Guia Da Instalação

Página de 137
2-6 
Installation 
78-748704-01 Rev C 
Connect RF Cables to the Chassis 
Introduction 
The following instructions explain how to make the RF cable connections for the 
processor. 
Connecting the RF Cables 
Follow these steps to connect the RF cables to the chassis. 
 
1. 
Locate the RF ports of the corresponding slot where the processor is to be 
installed.   
 
 
2. 
Attach one 75-ohm RF cable to the Port A connector (RF output 1A) of the 
corresponding slot where the module is to be installed.  This is the channel A1 
RF output connection.