Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Procedures
HNB-GW Service Configuration ▀
HNB-GW Administration Guide, StarOS Release 16 ▄
103
ipsec transform-setlist <ipsec_trans_set>
exit
ikev2-ikesa keepalive-user-activity
end
configure
context <vpn_ctxt_name>
hnbgw-service <hnbgw_svc_name>
security-gateway bind address <segw_ip_address> crypto-template <crypto_template>
context <segw_ctxt_name>
context <segw_ctxt_name>
end
Notes:
<
vpn_ctxt_name
> is name of the source context in which HNB-GW service is configured.
<
segw_ctxt_name
> is name of the context in which Se-GW service is configured. By default it takes context
where HNB-GW service is configured.
<
hnbgw_svc_name
> is name of the HNB-GW service which is to be configured for used for Iuh reference
between HNB-GW and HNB.
Multiple MSC Selection without Iu-Flex Configuration
Use the following example to configure the multiple MSC selection over IuCS interface for MSC pooling and sharing.
configure
cs-network <cs_network_name>
associate sccp-network <sccp_network_id>
map lac range <lac_start> to <lac_end> point-code <msc_point_code>
end
Notes:
<
cs_network_name
> is name of the HNB-CS network which is already configured and associated with HNB-
GW service.
<
sccp_network_id
> is the identifier used for the SCCP network which is already configured and associated
with HNB-CS Network <
cs_network_name
>.
LAC value must be an integer between 0 and 65535.