Cisco Cisco TelePresence MX700 Guia Da Instalação

Setting the menu password using the command line interface

When starting up the system for the first time the Administrator

Settings menu password is not set.

A warning on the screen of your video system indicates if no

administrator password is set. to remove the warning you must

set an administrator password. if you wish to remove the warning

without setting a password, you can leave the password field

blank, though this is not advisable.

NoTe:

We strongly recommend that you define a password to

protect the Administrator Settings menu, since these settings

affect the behavior of the video conference system.

the Administrator Settings menu password cannot be set

using the touch controller. if your system does not have a

remote control, you have to set the menu password from the

command line interface.

Signing in to the command line interface

1. to find the iP address of the system, tap

More > Settings >

System Information

on the touch controller.

the iPv4 Address and/or iPv6 Address is listed in the

Network

section.

2. open a command line interface (SSH or telnet) using the

system's iP address.

3. enter your codec/system user name and password when

prompted.
the default user name is

admin

with no password set.

Setting the menu password

1. Connect to the system through the network or the serial

data port, using a command line interface (SSH or telnet).

2. type the following command:

xCommand SystemUnit MenuPassword Set

Password: <password>

the password format is a string with 0–255 characters.

Back to task overview

Cisco telePresence Video Systems

d14639.08 Video Systems Getting Started Guide tC6.0, february 2013.

Getting Started Guide

Contents

Introduction

User interfaces

Configuration

Appendices

Contacts

Configuration