Cisco Cisco TelePresence MX700 Manual De Manutenção
Auto-registration of the endpoint
Only applicable when the CUCM is not set to mixed mode;
not applicable for endpoints connected to CUCM via
Expressway.
Configuration of the CUCM for auto-registration of the
endpoint is described on this page.
Auto-registration of the TelePresence endpoint is
not possible when the CUCM is set to mixed mode
(cluster security mode).
Use the search options available on the page, or leave the
search field blank and press Find to list the available CUCMs.
• Choose the one you would like to configure; this will take
you to the Cisco Unified CM Configuration page.
Enable auto-registration
Navigate to the Auto-registration Information section.
Starting Directory Number: Enter the lowest number in
the range of directory numbers.
Ending Directory Number: Enter the highest number in the
range of directory numbers.
Auto-registration Disabled on this Cisco Unified
Communications Manager: Uncheck the checkbox to
enable auto-registration.
When done click
Save and Apply Config.
Navigate to the
Auto-registration Information section.
Navigate to: System > Cisco Unified CM.
Click
Find and choose the CUCM from the list.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.09 Administering TC7.2 Endpoints on CUCM 10.5.1, NOVEMBER 2014.
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
37
Mandatory Optional
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
CUCM configuration