Cisco Cisco Web Security Appliance S360 Guia Do Utilizador
3-2
Cisco AsyncOS for Web User Guide
Chapter 3 Connect, Install, and Configure
Connecting the Appliance
Connecting the Appliance
Before You Begin
•
Follow the instructions in the Cisco 170 Series Hardware Installation Guide to mount the appliance,
cable the appliance for management, and connect the appliance to power.
cable the appliance for management, and connect the appliance to power.
•
If you plan to physically connect the Appliance to a WCCP v2 router for transparent redirection,
first verify that the WCCP router supports Layer 2 redirection.
first verify that the WCCP router supports Layer 2 redirection.
•
Be aware of Cisco configuration recommendations:
–
Use simplex cabling (separate cables for incoming and outgoing traffic) if possible for enhanced
performance and security.
performance and security.
Step 1
Connect the Management interface if you have not already done so:
3.
Run the System Setup Wizard.
4.
(Optional) Connect upstream proxies.
Task
More Information
Ethernet Port
Notes
M1
Connect M1 to where it can:
•
Send and receive Management traffic.
•
(Optional) Send and receive web proxy data traffic.
You can connect a laptop directly to M1 to administer the appliance.
To connect to the management interface using a hostname
(http://hostname:8080), add the appliance hostname and IP address to your DNS
server database.
(http://hostname:8080), add the appliance hostname and IP address to your DNS
server database.
P1 and P2 (optional)
•
Available for outbound management services traffic but not administration.
•
Enable "Restrict M1 port to appliance management services only” Network
> Interfaces page.
> Interfaces page.
•
Set routing for the service to use the Data interface.