Brother RJ-2140 Guia De Configuração Rápida
Stopping Rechargeable Li-ion Battery Charging
To stop the battery charging, disconnect the AC adapter or car adapter from
the DC connector.
Notes on Using the Rechargeable Li-ion Battery
High density (dark) printing discharges the battery faster than low density
printing. You can adjust the print density setting in the Printer Setting Tool
(see the User's Guide).
printing. You can adjust the print density setting in the Printer Setting Tool
(see the User's Guide).
The battery charging must take place between 41°F and 95°F (5°C and
35°C) environments, otherwise the battery will not be charged. If the
charging stops because the environment temperature is too low or too
high, place your printer in an environment with a temperature between
41°F and 95°F (5°C and 35°C) and try charging again.
35°C) environments, otherwise the battery will not be charged. If the
charging stops because the environment temperature is too low or too
high, place your printer in an environment with a temperature between
41°F and 95°F (5°C and 35°C) and try charging again.
If you use your printer when both the battery is installed and the AC
adapter or car adapter is connected, charging may stop temporarily even
if the battery is not fully charged.
adapter or car adapter is connected, charging may stop temporarily even
if the battery is not fully charged.
Rechargeable Li-ion Battery Characteristics
To ensure the highest performance and longest life from the battery:
Do not use or store the battery in a location exposed to extreme high or low
temperatures as it may deteriorate more quickly.
temperatures as it may deteriorate more quickly.
Remove the battery when storing your printer for long periods of time.
Store batteries with less than a 50% charge in a cool dry place out of direct
sunlight.
sunlight.
Recharge the battery every six months if it is stored for long periods of
time.
time.
It is normal and safe for the printer to become warm while charging.
Disconnect the charger and stop using the printer if it becomes hot to the
touch.
Disconnect the charger and stop using the printer if it becomes hot to the
touch.
For RJ-2030/2050
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
2.
Insert the media roll into the media roll compartment with the roll feeding
from the bottom as shown.
3.
Close the media roll compartment by pressing down on the center of the
cover until it locks into place.
For RJ-2140/2150
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
2.
Open the roll guides by lifting up the roll guide adjustment lever and
pulling the roll guide outwards.
Insert the media roll into the media roll compartment with the roll feeding
from the bottom as shown.
3.
While lifting up the roll guide adjustment lever, push in both roll guides
to the roll width. Insert the media roll so that it is positioned straight in
the media roll compartment.
4.
Close the media roll compartment by pressing down on the center of the
cover until it locks into place.
On: Press and hold the (Power) button until the LCD turns on.
Off: Press and hold the (Power) button until the message [System Off]
Off: Press and hold the (Power) button until the message [System Off]
appears on the LCD.
Inserting the Paper or Label Roll
1
Cover open lever
1
Print surface
(faces outwards on the roll)
1
1
1
Cover open lever
1
Roll guide adjustment lever
2
Roll guide
3
Print surface
(faces outwards on the roll)
Powering On or Off
IMPORTANT
Do NOT remove the battery until the LCD turns off.
1
1
1
2
2
3