Brother CM350H Guia De Configuração Rápida
Use the spatula to peel off the
cutout pattern.
Peel off the material.
7
Select “Cut”.
Press “Start/Stop Button” to start cutting.
Press “Feed Button” to feed out the mat.
5
6
4
Check the pattern
arrangement.
Select “Pattern”.
Select a test pattern.
Touch the “Test” key.
Touch the “Set” key.
Hold the mat level and
insert it.
Insert the mat so that it
*
is tucked under the feed
rollers.
Press “Feed Button” to
load the mat.
1
2
3
If the material is not cut
cleanly, refer to “Adjusting
the Blade Extension” on the
front of this sheet, and then
adjust the blade extension.
If the material is cut cleanly,
begin working on your
project.
Trial Cutting
Installing the Holder
Twist off the holder cap to
remove it.
Using a commercially
available brush, clean off
cuttings, lint and dust.
Turn off the machine and store away the operation panel.
While pushing in the tab at the bottom of the machine, pull up
on the cover.
Dampen a soft lint-free cloth with water and firmly wring it out,
and then wipe the scanner glass at the inside on the bottom of
the machine.
Fit the tab on the cover into the notch of the installation slot,
and then attach the cover to the machine.
After cleaning, perform a test scan.
*
1
Notch
1
Raise the holder lock lever.
Insert the holder into the
carriage.
Push down on the holder
lock lever.
Turn on the machine.
Select “Pattern”.
1
5
Select the pattern category.
2
Select the pattern.
Edit the pattern.
3
Check the pattern
arrangement.
4
Change the pattern
arrangement.
Cutting a Selected Pattern (Clover)
Touch the “OK” key.
6
Continue by following the
procedure starting with step
3
in “Trial Cutting”.
Select “Scan”.
1
Press “Feed Button” to load the
mat.
5
Select “Direct Cut”.
2
Attach the original (stamped
paper, printed paper/sticker,
etc.) to the mat.
3
“Direct Cut” function: An
original illustration can be
scanned and its outline can
be cut out.
4
Hold the mat level and insert it.
Using “Direct Cut” Mode to Cut a Pattern Drawn on Material
Touch the “OK” key.
7
Press “Start/Stop Button”
to start scanning.
6
Touch the “OK” key.
8
Select the area to be cut.
Press “Feed Button” to feed out
the mat.
11
Touch the “Cut” key.
9
Press “Start/Stop Button” to start
cutting.
10
Use the spatula to peel off
the cutout pattern.
Peel off the material.
12
Cleaning the Holder
Clean the holder after every use.
Cleaning the Scanner Glass
If the image, design, or photograph does not scan properly to create cut data, clean the scanner glass.