Samsung HT-F9750W Manual Do Utilizador

English  

 

|

03

Connections

Surround 

Speaker (L)

Surround 

Speaker (R)

Subwoofer

Centre Speaker

Front/Front Top 
Speaker (L)

Front/Front Top 
Speaker (R)

Wireless Receiver Module

* This product should be connected with the SWA-6000 only.

| CAUTION |

 

If you want to install the product on the wall, fasten the screws or nails on the wall firmly and use the holes on the 
rear of speaker to install. However, when you install it, accessories (nails or screws) and installation is not provided by 
the company.

 

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

 

When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.

 

  Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien 
substances into the duct (hole) of the subwoofer speaker.

 

 Do not hang the subwoofer on the wall using the duct (hole).

 

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.

 

For optimal listening performance, make sure that the area around the wireless receiver module location is clear of 
any obstructions.

 

If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.

 

In 2-CH mode, you will hear no sound from the wireless surround speakers.

| NOTES |

 

 If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.

 

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to 
the product, sound from the speakers may be disrupted because of interference.

 

If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment or any other device that uses 
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.

 

The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary 
depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the 
wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

 

If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless 
receiver module. With the product turned off, press "0"

"1""3""5" on the remote control. Turn on the wireless 

receiver module. Then, press and hold the “ID SET” button on the back of the wireless receiver module for 5 
seconds, and then turn the product on.

HT-F9750W-XU_0604.indd   17

HT-F9750W-XU_0604.indd   17

2013-06-04   오전 9:18:47

2013-06-04   오전 9:18:47