Samsung SNT-1010P Manual Do Utilizador

Chapter 3 Network Connection &Setup

To Connect SNT-1010 to an IP sharer with the xDSL/Cable modem/Connect SNT-1010 to an IP sharer with local area networking

[ STEP 5 ] To connect a local PC in the IP sharer to SNT-1010

[ STEP 6 ] To connect to SNT-1010 from a remote PC

Network Connection & Setup

To Connect SNT-1010 to an IP sharer with the xDSL/Cable modem

(Continued)

Run the IP Installer on your local PC and search for SNT-1010.

If found, double-click the SNT-1010 to start the Internet browser and try to connect to
SNT-1010. Alternately, launch the Internet browser manually and enter the IP address of the
SNT-1010 found in the address bar to connect to it.
ex) http://192.168.1.2

You can’t use the IP Installer on a remote PC that is not connected to the IP sharer.
This is because the IP Installer does not work on the Internet.

You can use DDNS URL of SNT-1010 to connect to the IP sharer internal SNT-1010.

However, you must set the port-forwarding for the IP sharer before you can connect to the IP
sharer internal SNT-1010 from a remote PC.

For more information on the port-forwarding, refer to Use IP Sharer: Port Forwarding Setting
(Port Mapping).

When the port forwarding is done, run the Internet browser on the remote PC and enter the
DDNS URL address or, the Internet IP address of the IP sharer in the address bar for
connecting to SNT-1010.
ex) http://mfffe42.websamsung.net

For the DDNS URL address, refer to “To check the DDNS address” on page 41.

Local PC

SNT-1010 1

SNT-1010 2

IP Sharer External PC

Firewall

IP Sharer

Switch

HUB

External

Remote PC

DDNS Server

(Data Center, KOREA)

Network Connection & Setup

Connect SNT-1010 to an IP sharer with local area networking

This is for a large network environment such
as corporate office, building, public office
and factory.

To configure the network settings of the local PC connected to an IP sharer, follow the instructions below.

Select : <Network Neighborhood>

<Properties>

<Local Area Connection>

<Properties>

<General>

<Internet Protocol (TCP/IP)>

<Properties>

<Obtain an IP address automatically> or <Use the following IP address>

Follow the instructions below if you select <Use the following IP address>:

ex1) If the address (LAN IP)of the IP sharer is 192.168.1.1

IP address : 192.168.1.100

Subnet Mask : 255.255.255.0

Default Gateway : 192.168.1.1

ex2) If the address (LAN IP)of the IP sharer is 192.168.0.1

IP address : 192.168.1.100
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.0.1

ex3) If the address (LAN IP)of the IP sharer is 192.168.xxx.1

IP address : 192.168.1.100
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.xxx.1

[ STEP 1 ] To configure the network settings of the local PC connected to an IP sharer

For the address of the IP sharer, refer to the product’s documentation.

Note