Samsung RF56J9071SR Manual Do Utilizador

English - 25

SETTING

 UP

INSTALLING THE WATER 

DISPENSER LINE

A water dispenser with a filter is one of the helpful 

features on your new refrigerator. 

To help promote better health, the water filter 

removes unwanted particles from your water. 

However, it does not sterilize or destroy 

microorganisms. 

You may need to purchase a water purifying 

system to do that. 

The water line also connects to the ice maker. 

For the ice maker to operate properly, water 

pressure of 138 ~ 862 kPa is required. 

If the refrigerator is installed in an area with low 

water pressure (below 20 psi), you can install a 

booster pump to compensate for the low pressure. 

After you have connected the water line, make 

sure the water storage tank inside the refrigerator is 

properly filled. 

To do this, press the water dispenser lever until the 

water runs from the water outlet.

•  Water line installation kits are available at 

extra cost from your dealer.  

We recommend using a water line 

installation kit that contains copper 

tubing and 6 mm (¼”) compression nut.

•  The new hose-sets supplied with the appliance 

are to be used and that old hose-sets should 

not be reused.

Connecting to the water supply line

1.  First, shut off the main water 

supply.

2.  Locate the nearest cold water drinking line and 

install the pipe clamp and shut off valve.

3.  Connect the water line installation kit to the shut 

off valve.

Shut off valve

Pipe clamp

Cold water line

Water line installation 

kit

Connecting the water supply line to the 

refrigerator

There are several items that you need to purchase 

to complete this connection. 

You may find these items sold as a kit at your local 

hardware store.

Use Copper Tubing

Use Plastic Tubing

•  ¼” copper tubing

•  ¼” compression nut (1pc)

•  Ferrule (2pc)

•  ¼” plastic tubing  

→

 Molded end (Bulb)

•  ¼” compression nut (1pc)

DA68-03194L-01.indb   25

2015. 8. 26.   �� 9:57